EasyManuals Logo

Cisco RV215W Administration Guide

Cisco RV215W
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #108 background imageLoading...
Page #108 background image
Configuring VPN
Configuring Advanced VPN Parameters
Cisco RV215W Wireless-N VPN Firewall Administration Guide 108
9
- AES-192
- AES-256
Authentication Algorithm—Specify the authentication algorithm for the
VPN header:
- MD5
- SHA-1
- SHA2-256
Ensure that the authentication algorithm is configured identically on both
sides of the VPN tunnel (for example, the device and the router to which
it is connecting).
Pre-Shared Key—Enter the key in the space provided. Note that the
double-quote character (“) is not supported in the pre-shared key.
Diffie-Hellman (DH) Group—Specify the DH Group algorithm, which is
used when exchanging keys. The DH Group sets the strength of the
algorithm in bits. Ensure that the DH Group is configured identically on both
sides of the IKE policy.
SA Lifetime—Enter the interval, in seconds, after which the Security
Association becomes invalid.
Dead Peer DetectionCheck the Enable box to enable this feature, or
uncheck the box to disable it. Dead Peer Detection (DPD) is used to detect
whether the peer is alive or not. If the peer is detected as dead, the router
deletes the IPsec and IKE Security Association. If you enable this feature,
also enter these settings:
- DPD Delay—Enter the interval, in seconds, between consecutive DPD
R-U-THERE messages. DPD R-U-THERE messages are sent only when
the IPsec traffic is idle.
- DPD Timeout—Enter the maximum time that the device should wait to
receive a response to the DPD message before considering the peer to
be dead.
STEP 3 Check the XAUTH Type Enable check box to configure extended authentication
for your IPsec VPN policy. Provide the authentication username and password.
STEP 4 Click Save.

Table of Contents

Other manuals for Cisco RV215W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco RV215W and is the answer not in the manual?

Cisco RV215W Specifications

General IconGeneral
VPN support3DES, PPTP, L2TP
Ethernet LANYes
Cabling technology10/100Base-T(X)
Networking standardsIEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1p, IEEE 802.1Q
VPN tunnels quantity6
Ethernet LAN data rates10, 100 Mbit/s
Ethernet LAN interface typeFast Ethernet
Wi-Fi bandNo
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Top Wi-Fi standardWi-Fi 4 (802.11n)
Ethernet LAN (RJ-45) ports4
Input current1.67 A
Supported protocolsPPPoE, PPTP, L2TP, RSTP, NAT, DynDNS, PAT, DMZ
Security algorithmsWEP, WPA, WPA2, WPS
Antennas quantity2
CertificationFCC Class B, CE, IC, UL, cUL, Wi-Fi, C-Tick
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Storage relative humidity (H-H)5 - 90 %
Operating relative humidity (H-H)10 - 85 %
Product colorBlack
Weight and Dimensions IconWeight and Dimensions
Width150 mm
Height30 mm
Weight300 g

Related product manuals