Cisco RV215W - Configuring DSCP Settings

Configuring Quality of Service (QoS)
Configuring DSCP Settings
Cisco RV215W Wireless-N VPN Firewall Administration Guide 121
10
These values mark traffic types with higher or lower traffic priority depending on
the type of traffic.
STEP 4 Click Save.
To restore the default port-based QoS settings, click Restore Default, and click
Save.
Configuring DSCP Settings
You can use the DSCP Settings page to configure DSCP-to-QoS queue mapping.
To configure DSCP-to-QoS queue mapping:
STEP 1 Choose QoS > DSCP Settings.
STEP 2 Choose the Ethernet or 3G radio button.
STEP 3 Choose whether to only list RFC values or to list all DSCP values in the DSCP
Settings Table by clicking the relevant button.
STEP 4 For each DSCP value in the DSCP Settings Table, choose a priority level from the
Queue drop-down menu.
This maps the DSCP value to the selected QoS queue.
STEP 5 Click Save.
To restore the default DSCP settings, click Restore Default and Save.