Cisco RV215W - Configuring Bandwidth; Configuring Bandwidth Priority

Configuring Quality of Service (QoS)
Configuring Bandwidth Management
Cisco RV215W Wireless-N VPN Firewall Administration Guide 117
10
Configuring Bandwidth
You can limit the bandwidth to reduce the rate at which the device transmits data.
You can also use a bandwidth profile to limit the outbound traffic, which prevents
the LAN users from consuming all of the bandwidth of the Internet link.
To set the upstream and downstream bandwidth:
STEP 1 Choose QoS > Bandwidth Management.
STEP 2 In the Bandwidth Management field, check Enable. The maximum bandwidth
provided by your ISP appears in the Bandwidth section.
STEP 3 In the Bandwidth Table, enter the following information for the WAN interface:
STEP 4 Click Save.
Configuring Bandwidth Priority
In the Bandwidth Priority Table, you can assign priorities to services to manage
bandwidth usage.
To configure bandwidth priority:
STEP 1 Choose QoS > Bandwidth Management.
STEP 2 In the Bandwidth Management field, check Enable. The maximum bandwidth
provided by your ISP appears in the Bandwidth section.
STEP 3 In the Bandwidth Priority Table, click Add Row.
Upstream The bandwidth (kb/s) used for sending data to the
Internet.
Downstream The bandwidth (kb/s) used for receiving data from
the Internet.