Cisco RV215W - Editing the Wireless Network Settings

Configuring the Wireless Network
Configuring Basic Wireless Settings
Cisco RV215W Wireless-N VPN Firewall Administration Guide 71
7
Editing the Wireless Network Settings
The Wireless Table in the Basic Settings page (Wireless > Basic Settings) lists
the settings of the four wireless networks supported on the device.
To configure wireless network settings:
STEP 1 Check the box for the networks you want to configure.
STEP 2 Click the Edit button.
STEP 3 Configure these settings:
STEP 4 Click Save.
Enable SSID Click On to enable the network.
SSID Name Enter the name of the network.
SSID Broadcast Check this box to enable SSID broadcast. If
SSID broadcast is enabled, the wireless router
advertises its availability to wireless-equipped
devices in the range of the router.
VLAN Choose the VLAN associated with the network.
Wireless Isolation with SSID Check this box to enable wireless isolation
within the SSID.
WMM (Wi-Fi Multimedia) Check this box to enable WMM.
WPS Hardware Button Check this box to map the device WPS button
on the front panel to this network.