Chapter 3 Setting Up the Cisco Secure ACS HTML Interface
Protocol Configuration Options for RADIUS
3-14
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version. 3.0
Setting Protocol Configuration Options for RADIUS (Cisco
IOS/PIX)
This procedure allows you to enable the Cisco IOS/PIX RADIUS VSA. Selecting
this attribute displays an entry field under User Setup and/or Group Setup in
which any TACACS+ commands can be entered to fully leverage TACACS+ in
a RADIUS environment.
Note If the Per-user TACACS+/RADIUS Attributes check box in Interface
Configuration: Advanced Options is selected, a User check box appears
alongside the Group check box for each attribute.
To set protocol configuration options for the Cisco RADIUS attribute follow
these steps:
Step 1 Click Interface Configuration.
Step 2 Click RADIUS (Cisco IOS/PIX).
Result: The RADIUS (Cisco IOS/PIX) page appears.
Step 3 Select the check box for either User or Group, or both, next to attribute number
26, the VSA for Cisco.
Step 4 Click Submit at the bottom of the page.
Result: According to your selections, the attribute for the Cisco RADIUS VSA
appears on the User Setup or Group Setup pages, or both, as a configurable option
with a field in which you can enter TACACS+ commands.
Setting Protocol Configuration Options for RADIUS (Ascend)
This procedure enables you to hide or display RADIUS (Ascend) attributes for
configuration from other portions of the Cisco Secure ACS HTML interface.
To Next Page
Loading...
Need help?
General