6-3
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Chapter 6 Setting Up and Managing User Groups
Common User Group Settings
Cisco Secure ACS also enables you to enter and configure new TACACS+
services. For information about how to configure a new TACACS+ service to
appear on the group setup page, see the “Protocol Configuration Options for
TACACS+” section on page 3-7.
You can use the Shell Command Authorization Set feature to configure TACACS+
group settings. This feature enables you to apply shell commands to a particular
user group in the following ways:
• Assign a shell command authorization set, which you have previously
configured, for any network device.
• Assign a shell command authorization set, which you have previously
configured, to particular NDGs.
• Permit or deny specific shell commands, which you define, on a per-group
basis.
For more information about shell command authorization sets, see Chapter 5,
“Setting Up and Managing Shared Profile Components.”
Common User Group Settings
This section presents the basic activities you perform when configuring a new
user group. This section contains the following procedures:
• Enabling VoIP Support for a User Group, page 6-4
• Setting Default Time of Day Access for a User Group, page 6-5
• Setting Callback Options for a User Group, page 6-6
• Setting Network Access Restrictions for a User Group, page 6-7
• Setting Max Sessions for a User Group, page 6-11
• Setting Usage Quotas for a User Group, page 6-13
To Next Page
Loading...
Need help?
General