2-3
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Chapter 2 Deploying Cisco Secure ACS
Basic Deployment Requirements for Cisco Secure ACS
Operating System Requirements
Your Cisco Secure ACS server must have an English-language version of one of
the following Microsoft Windows operating systems installed:
• Windows 2000 Server with Service Pack 1 or Service Pack 2 installed
• Windows 2000 Advanced Server, with these additional requirements:
–
without Microsoft Clustering Services installed
–
with Service Pack 1 or Service Pack 2 installed.
• Windows 2000 Datacenter Server, with these additional requirements:
–
without Microsoft Clustering Services installed
–
with Service Pack 1 or Service Pack 2 installed.
• Windows NT Server 4.0 with Service Pack 6a installed.
Windows Service Packs can be applied either before or after installing
Cisco Secure ACS. If you do not install a required Service Pack before installing
Cisco Secure ACS, the Cisco Secure ACS installation program warns you that the
required Service Pack is not present on your server. If you receive a Service Pack
message, continue the installation, and then install the required Service Pack
before starting user authentication with Cisco Secure ACS.
For the latest information about tested operating systems and service packs, see
the Release Notes. The latest version of the Release Notes are posted at
http://www.cisco.com.
Third-Party Software Requirements
Your Cisco Secure ACS server must have a compatible browser installed.
Cisco Secure ACS has been tested with the following browsers on Microsoft
Windows operating systems:
• Microsoft Internet Explorer 5.0 and 5.5
• Netscape Communicator 4.76
Note Both Java and JavaScript must be enabled in browsers used to administer
Cisco Secure ACS.
To Next Page
Loading...
Need help?
General