Chapter 7 Setting Up and Managing User Accounts
Basic User Setup Options
7-4
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Basic User Setup Options
This section presents the basic activities you perform when configuring a new
user. At its most basic level, configuring a new user requires only three steps, as
follows:
• Specify a name
• Specify either a method for remote password authentication or, for
authentication via the CiscoSecure user database, a password
• Submit the information
For detailed procedural information, see the “Adding a Basic User Account”
section on page 7-5.
What other procedures you perform when setting up new user accounts is a
function both of the complexity of your network and of the granularity of control
you desire. The other basic procedures detailed in this section include the
following:
• Setting Supplementary User Information, page 7-7
• Setting a Separate CHAP/MS-CHAP/ARAP Password, page 7-8
• Assigning a User to a Group, page 7-9
• Setting User Callback Option, page 7-10
• Assigning a User to a Client IP Address, page 7-11
• Setting Network Access Restrictions for a User, page 7-12
• Setting Max Sessions Options for a User, page 7-17
• Setting User Usage Quotas Options, page 7-19
• Setting Options for User Account Disablement, page 7-21
• Assigning a PIX ACL to a User, page 7-22
Beyond these basic user setup options, there are also procedures for configuring
a user account for authentication via TACACS+ and RADIUS; these procedures
are located under the “Advanced User Authentication Settings” section on
page 7-23.
To Next Page
Loading...
