6-35
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Chapter 6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
To configure IETF RADIUS attribute settings to be applied as an authorization for
each user in the current group, follow these steps:
Step 1 In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
Step 2 From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
Step 3 From the Jump To list at the top of the page, choose RADIUS (IETF).
Step 4 For each IETF RADIUS attribute you need to authorize for the current group,
select the check box next to the attribute and then further define the authorization
for the attribute in the field or fields next to it.
Step 5 To save the group settings you have just made, click Submit.
For more information, see the “Saving Changes to User Group Settings” section
on page 6-50.
Step 6 To configure the vendor-specific attributes (VSAs) for any RADIUS network
device vendor supported by Cisco Secure ACS, see the appropriate section:
• Configuring Cisco IOS/PIX RADIUS Settings for a User Group, page 6-36
• Configuring Ascend RADIUS Settings for a User Group, page 6-37
• Configuring Cisco VPN 3000 Concentrator RADIUS Settings for a User
Group, page 6-38
• Configuring Cisco VPN 5000 Concentrator RADIUS Settings for a User
Group, page 6-39
• Configuring Microsoft RADIUS Settings for a User Group, page 6-41
• Configuring Nortel RADIUS Settings for a User Group, page 6-42
• Configuring Juniper RADIUS Settings for a User Group, page 6-44
• Configuring Cisco BBSM RADIUS Settings for a User Group, page 6-45
Step 7 To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
To Next Page
Loading...
Need help?
General