Chapter 6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
6-40
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
To configure and enable Cisco VPN 5000 Concentrator RADIUS attributes to be
applied as an authorization for each user in the current group, follow these steps:
Step 1 Confirm that your IETF RADIUS attributes are configured properly.
For more information about setting IETF RADIUS attributes, see the
“Configuring IETF RADIUS Settings for a User Group” section on page 6-34.
Step 2 In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
Step 3 From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
Step 4 From the Jump To list at the top of the page, choose RADIUS (Cisco VPN 5000).
Step 5 In the Cisco VPN 5000 Concentrator RADIUS Attributes table, select the
attributes that should be authorized for the group by selecting the check box next
to the attribute. Further define the authorization for each attribute in the field next
to it.
For more information about attributes, see Appendix D, “RADIUS Attributes,” or
the documentation for network devices using RADIUS.
Step 6 To save the group settings you have just made, click Submit.
For more information, see the “Saving Changes to User Group Settings” section
on page 6-50.
Step 7 To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
To Next Page
Loading...
Need help?
General