8-67
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Chapter 8 Establishing Cisco Secure ACS System Configuration
Cisco Secure ACS Certificate Setup
Step 4 Select the Use existing certificate option.
Step 5 You must specify whether the system should read the certificate from a specified
file or use a certificate already in storage on the local machine. Do one of the
following:
a. To specify that Cisco Secure ACS should read the certificate from a specified
file, select the Read certificate from file option, and then type the full
directory path and name of the certificate file in the Certificate file box.
b. To specify that Cisco Secure ACS should use a particular existing certificate
from local machine storage, select the Use certificate from storage option,
and then type the certificate CN (common name/subject name) in the
Certificate CN box (without the “cn=” prefix).
Step 6 If you generated the request using Cisco Secure ACS, in the Private key file box,
type the full directory path and name of the file that contains the private key.
Note If the certificate was installed in storage with the private key, you do
not have the private key file and do not need to type it.
Tip This is the private key associated with the server certificate.
Step 7 In the Private key password box, type the private key password.
Step 8 Click Submit.
Result: To show that the certificate setup is complete, Cisco Secure ACS displays
the Installed Certificate Information table, which contains the following
certificate information:
• Issued to: certificate subject
• Issued by: CA common name
• Valid from:
• Valid to:
• Validity
To Next Page
Loading...
Need help?
General