Cisco SG350-10MP Administration Guide

Multicast
IPv4 Multicast Configuration
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 275
15
STEP 4 To add protection to a VLAN, click Add and enter the following fields:
• Upstream Interface—Select the upstream interface. Since there is only a single
upstream interface, if one has already been selected, this field is grayed out.
• Downstream Interface—Select the downstream interface. There can be multiple
downstream interfaces.
• Downstream Protection—Select one of the following options:
- Use Global—Use the status set in the global block.
- Disable—This enables forwarding of IPv4 Multicast traffic from downstream
interfaces.
- Enable—This disables forwarding from downstream interfaces.
STEP 5 Click Apply. The Running Configuration file is updated.
The following fields are displayed for each IPv4 Multicast route:
• Source Address—Unicast source IPv4 address.
• Group Address—Multicast destination IPv4 address.
• Incoming Interface—Expected interface for a Multicast packet from the source. If the
packet is not received on this interface, it is discarded.
• Outgoing Interfaces—Interfaces through which packets will be forwarded.
• Uptime—Length of time in hours, minutes, and seconds that the entry has been in the
IP Multicast routing table.
• Expiry Time—Length of time in hours, minutes, and seconds until the entry is removed
from the IP Multicast routing table.

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)