Cisco Small Business SPA509G - Setting a Static IP Address

Configuring Security, Quality, and Network Features
Configuring Domain and Internet Settings
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 147
5
• Static IP—Configure a static IP address for the phone.
• PPPoE—Point-to-Point Protocol over Ethernet (PPPoE) relies on two widely
accepted standards: PPP and Ethernet. PPPoE is a specification for
connecting users on an Ethernet to the Internet through a common
broadband medium, such as a single DSL line, wireless device, or cable
modem. All users on an Ethernet share a common connection, so the
Ethernet principles supporting multiple users in a LAN combine with the
principles of PPP, which apply to serial connections.
NOTE PPPoE is only applicable to the Cisco SPA525G/525G2.
STEP 5 Click Submit All Changes.
NOTE For the Cisco SPA301 and Cisco SPA501G, can be configured using the IVR. See
the “Using IVR on the Cisco SPA301 and Cisco SPA501G IP Phone” section on
page 30.
Setting a Static IP Address
If you configured Static IP as the internet connection type:
STEP 1 Log in to the configuration utility.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the System tab.
STEP 4 Configure the following fields:
• Static IP Address—Enter the static IP address of the phone.
• Netmask—Enter the subnet mask of the phone.
• Gateway—Enter the IP address of the gateway.
For the SPA525G
/525G2, you also have the following fields available:
• LAN MTU—LAN Maximum Transmission Unit size. Default value: 1500.
• Duplex Mode—Choose one of the following to configure the speed/duplex
for the phone’s Ethernet ports:
- Auto
- 10MBps/Duplex
- 10MBps/Half