Cisco Small Business SPA509G - Resyncing a Phone; Rebooting a Phone

Provisioning Basics
Upgrading, Resyncing, and Rebooting Phones
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 174
6
Resyncing a Phone
You can resync an IP phone to a specific remote profile. The configuration of the
phone you resync will match the configuration of the remote phone. The phone
can be configured to resync its internal configuration state to a remote profile
periodically and on power up.
NOTE The phone resyncs only when it is idle.
Use the following syntax to resync a phone’s profile to a profile on a TFTP, HTTP, or
HTTPS server:
http://phone-ip-addr/admin/resync?protocol://server-
name[:port]/profile-pathname
• Parameter following resync? defaults to the Profile Rule setting on the web
server Provisioning page.
• Protocol defaults to TFTP.
• Server-name defaults to the host requesting the URL.
• Port defaults to:
- 69 for TFTP
- 80 for HTTP
- 443 for HTTPS
• Profile-path defaults to the path to the new resync profile (for example,
http://192.168.2.217admin/resync?tftp://192.168.2.251/spaconf.cfg).
Rebooting a Phone
You can remotely reboot a Cisco IP phone if needed.
Use the following syntax to reboot a phone:
http://phone-ip-address/admin/reboot