Cisco SPA IP Phone Field Reference
Regional Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 261
B
• Vertical Service Activation Codes, page 265
• Vertical Service Announcement Codes, page 271
• Outbound Call Codec Selection Codes, page 271
• Time (Cisco SPA525G/525G2 Only), page 274
• Language (Cisco SPA525G/525G2 Only), page 274
• Miscellaneous, page 274
Call Progress Tones
Parameter Description
Dial Tone Prompts the user to enter a phone number.
Defaults to 350@-19,440@-19;10(*/0/1+2).
Bluetooth Dial Tone (Cisco
SPA525G/525G2 only)
Tone that indicates a bluetooth headset is on and the
user can make a call.
Defaults to 350@-19,440@-19;1(0/*/0);10(*/0/1+2).
Outside Dial Tone Alternative to the Dial Tone. It prompts the user to enter
an external phone number, as opposed to an internal
extension. It is triggered by a, (comma) character
encountered in the dial plan.
Defaults to 420@-16;10(*/0/1).
Prompt Tone Prompts the user to enter a call forwarding phone
number.
Defaults to 520@-19,620@-19;10(*/0/1+2).
Busy Tone Played when a 486 RSC is received for an outbound
call.
Defaults to 480@-19,620@-19;10(.5/.5/1+2).
Reorder Tone Played when an outbound call has failed or after the far
end hangs up during an established call. Reorder Tone
is played automatically when <Dial Tone> or any of its
alternatives times out.
Defaults to 480@-19,620@-19;10(.25/.25/1+2).
To Next Page
Loading...
