Cisco Small Business SPA509G - Power Settings (SPA50 X;); Pppoe Settings (Cisco SPA525 G;525 G2 Only)

Cisco SPA IP Phone Field Reference
System Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 241
B
Power Settings (SPA50X/)
PPPoE Settings (Cisco SPA525G/525G2 Only)
Parameter Description
PoE Power Required Specifies the PoE power setting: Normal (default) or
Maximum.
When one or more attendant consoles are attached to
the phone, use Maximum to advertise to a PoE switch
that the phone will consume up to 12 W.
When no attendant consoles are attached, use
Minimum to advertise a required power budget of 6.5
Watts.
This parameter is not applicable to SPA301 and
SPA303 because they do not have attendant console
support.
Parameter Description
PPPoE Login Name Specifies the account name assigned by the ISP for
connecting on a Point-to-Point Protocol over Ethernet
(PPPoE) link.
PPPoE Login Password Specifies the password assigned by the ISP for
connecting on a Point-to-Point Protocol over Ethernet
(PPPoE) link.
PPPoE Service Name Specifies the service name assigned by the ISP for
connecting on a Point-to-Point Protocol over Ethernet
(PPPoE) link.