Customizing Cisco SPA and Wireless IP Phones
Configuring Bluetooth (Cisco SPA525G/525G2 only)
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 83
3
Initiating Pairing from the Cisco SPA525G2
STEP 1 Enable Bluetooth as described in the “Enabling Bluetooth (Cisco SPA525G/
525G2)” section on page 80.
STEP 2 Press the Setup button.
STEP 3 Scroll to User Preferences and press Select.
STEP 4 Scroll to Bluetooth Configuration and press Select.
STEP 5 Scroll to Bluetooth Mode and press the Right Arrow key to choose one of the
following:
• Handsfree—Your Cisco SPA525G2 will operate as a handsfree device with
a Bluetooth-enabled mobile phone.
• Both—Your Cisco SPA525G2 will operate with your Bluetooth-enabled
mobile phone or operate with a Bluetooth headset. Note that your Cisco
SPA525G2 will connect to only one device at a time (either the Bluetooth
headset or the Bluetooth-enabled mobile phone.)
If multiple Bluetooth devices are in range of the Cisco SPA525G2, the order
of devices in the Bluetooth Configuration > Bluetooth Profiles list is used,
and the device with a higher priority is activated first.
STEP 6 Scroll to Bluetooth Profiles and press the Right Arrow key to enter the profile
screen.
STEP 7 Press Scan to scan for your mobile phone.
NOTE Depending on the network environment (for example, the number of Bluetooth
devices and noise level), your Bluetooth headset may not appear on the found
devices list. Ensure the headset is powered on and has Bluetooth activated, and
retry the Scan.
STEP 8 In the Select a Bluetooth Device to Pair list, select the mobile phone to which you
want to pair and press Connect.
Initiating Pairing from Your Bluetooth-Enabled Mobile Phone
NOTE The procedure varies depending on your phone model. The following example
uses an Apple iPhone.
To Next Page
Loading...
