Cisco Small Business SPA509G - Configuring the Cisco SPA500 S Attendant Console

Configuring Dial Plans
Resetting the Control Timers
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 212
8
Resetting the Control Timers
You can use the following procedure to reset the default timer settings for all calls.
NOTE If you need to edit a timer setting only for a particular digit sequence or type of call,
you can edit the dial plan. See <Xref_Color>“About Dial Plans,” on page 201.
STEP 1 Log in to the configuration utility.
STEP 2 Click Admin Login and advanced.
STEP 3 Click Voice tab > Regional.
STEP 4 Scroll down to the Control Timer Values section.
STEP 5 Enter the desired values in the Interdigit Long Timer field and the Interdigit Short
Timer field. Refer to the definitions at the beginning of this section.