Customizing Cisco SPA and Wireless IP Phones
Configuring the Message Waiting Indicator
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 72
3
Configuring the Message Waiting Indicator
You can configure the message waiting indicator (MWI) for separate extensions on
the phone. The MWI lights based on the presence of new voicemail messages in
the mailbox. However, if the indicator at the top of your Cisco SPA300 Series or
Cisco SPA500 Series IP Phone is not lighting when voice mail is left, or you are not
seeing message waiting notifications on your WIP310:
STEP 1 Log in to the configuration utility.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the Ext <number> tab.
STEP 4 Under Call Feature Settings, in the Message Waiting field, choose yes.
STEP 5 Click Submit All Changes.
Configuring Ring Tones
You can define up to 12 ring tones for a Cisco SPA300 Series or Cisco SPA500
Series IP Phone.
By default, 12 ring tones are readily available to users. In addition to these 12 ring
tones, 4 user-configurable ring tones can be used in place of some of the default
ones. See Appendix B, “Ring Tone (Cisco SPA300 Series and Cisco SPA500
Series),” for more information about all the ring tones that can be used.
NOTE WIP310 ring tones are not configurable from the configuration utility.
You can define:
• The default ring tone for the extension
• Specific ring tones assigned to individual callers in the personal directory.
These override the default ring tone.
To configure ring tones:
STEP 1 Log in to the configuration utility.
STEP 2 Click Admin Login and advanced.
To Next Page
Loading...
