Getting Started
Using the Web-Based Configuration Utility
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 22
1
• Cisco SPA303, Cisco SPA502G, Cisco SPA504G, Cisco SPA508G, Cisco
SPA509G: Press the Setup button, then select Network. The
Current IP
field
shows the phone’s current IP address.
• WIP310: In the Home screen, press Options and highlight
Phone Info
. Press
the Select button.
• Cisco SPA525G/525G2: Press the Setup button, then select Status. Select
Network Status
. The IP address is displayed.
STEP 3 Enter the IP address in your web browser address bar. For example:
http://192.168.1.8
NOTE If your service provider disabled access to the configuration utility, you must
contact the service provider.
If you have trouble accessing the configuration utility, perform the following steps:
Cisco SPA303, Cisco SPA502G, Cisco SPA504G, Cisco SPA508G,
Cisco SPA509G
STEP 1 Press the Setup button on the phone.
STEP 2 Select Network.
STEP 3 Scroll to Enable Web Server and make sure that it is set to Ye s . If not, press the
Edit soft key and press y/n soft key to set it to Ye s.
STEP 4 Press OK, then press Save.
Cisco SPA501G
STEP 1 Press the Setup button on the phone.
STEP 2 In the IVR menu, enter 7932.
STEP 3 Press 1 to enable the web server, then press #.
STEP 4 To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
To Next Page
Loading...
