Contents
xxviii
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
Disabling DVMRP Autosummarization 32-48
Adding a Metric Offset to the DVMRP Route 32-48
Monitoring and Maintaining IP Multicast Routing 32-49
Clearing Caches, Tables, and Databases 32-50
Displaying System and Network Statistics 32-50
Monitoring IP Multicast Routing 32-51
CHAPTER
33 Configuring MSDP 33-1
Understanding MSDP 33-1
MSDP Operation 33-2
MSDP Benefits 33-3
Configuring MSDP 33-4
Default MSDP Configuration 33-4
Configuring a Default MSDP Peer 33-4
Caching Source-Active State 33-6
Requesting Source Information from an MSDP Peer 33-8
Controlling Source Information that Your Switch Originates 33-9
Redistributing Sources 33-9
Filtering Source-Active Request Messages 33-11
Controlling Source Information that Your Switch Forwards 33-12
Using a Filter 33-12
Using TTL to Limit the Multicast Data Sent in SA Messages 33-14
Controlling Source Information that Your Switch Receives 33-14
Configuring an MSDP Mesh Group 33-16
Shutting Down an MSDP Peer 33-16
Including a Bordering PIM Dense-Mode Region in MSDP 33-17
Configuring an Originating Address other than the RP Address 33-18
Monitoring and Maintaining MSDP 33-19
CHAPTER
34 Configuring Fallback Bridging 34-1
Understanding Fallback Bridging 34-1
Configuring Fallback Bridging 34-2
Default Fallback Bridging Configuration 34-3
Fallback Bridging Configuration Guidelines 34-3
Creating a Bridge Group 34-3
Adjusting Spanning-Tree Parameters 34-5
Changing the VLAN-Bridge Spanning-Tree Priority 34-6
Changing the Interface Priority 34-6
Assigning a Path Cost 34-7
To Next Page
Loading...
