FreeSpeak II for Eclipse | User Guide
5.5.1 Setting the display and LED brightness
Use this setting to control the brightness of the display. The beltpack automatically dims after a
timeout period if no key is used or there is no incoming call or call alert. You can adjust the
timeout period.
When the beltpack is dimmed, the display goes off after a timeout period if no key is used or
there is no incoming call or call alert. You can adjust the timeout period.
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Display Options > Brightness
Level
3. Use either rotary control to select the dim level between 1 and 5 (default).
4. To confirm the selection and exit the menu screen, press the Menu Select key.
5.5.2 Setting the display dim timeout
Use this setting to determine when the beltpack display will dim if no key is used or there is no
incoming call or call alert.
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Display Options > Dim Timeout
3. Use either rotary control to select the dim level between Off and 120 seconds (default).
Setting the dim timeout to Off disables the timeout function.
4. To confirm the selection and exit the menu screen, press the Menu Select key.
5.5.3 Setting the display off timeout
Use this setting to determine when a dimmed beltpack display will switch off.
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Display Options > Off Timeout
3. Use either rotary control to select the dim level between Off and 120 seconds (35 second
default).
Setting the display off timeout to Off disables the timeout function.
4. To confirm the selection and exit the menu screen, press the Menu Select key (D).
5.6 Configuring the beltpack alarm options
You can configure the following alarm options:
Page 48
To Next Page
Loading...
Need help?
General
