Clear-Com FSII-TCVR-IP-19-US - Upgrading the FS II IP Transceiver Firmware; Upgrading from the Matrix

FreeSpeak II for Eclipse | User Guide
l
If the IPT is using a local power supply, adding a PoE connection causes no power
interruption.
l
If the IPT is using a PoE connection, adding a local power supply interrupts the power
supply for 1 to 2 seconds.
l
If the IPT is using both local and PoE, if you remove the local power supply connection,
the IPT power supply is interrupted for 1 to 2 seconds and then continues using the PoE
supply.
l
If the IPT is using both local and PoE, if you remove the PoE connection, the IPT
continues to operate without interruption using the local power supply.
6.12 Upgrading the FS II IP Transceiver firmware
You can upgrade the transceiver firmware by:
l
Upgrading from the matrix (the file extension for the upgrade firmware is .fww)
l
Using a USB connection (the file extension for the upgrade firmware is .fws)
6.13 Upgrading from the matrix
1. Right-click on the Frame in the Layout window, and then select Firmware > Update
Firmware. The Update Firmware Wizard appears.
2. Select Next. The following screen appears:
Note: For IPT Transcievers, the Auto/Promoted radio button is always set to Auto.
Page 74