Clear-Com FSII-TCVR-IP-19-US - Registering Beltpacks; Upgrading FS II Transceiver Firmware; Upgrading by USB Connection

FreeSpeak II for Eclipse | User Guide
7.10 Registering beltpacks
Before you can use a beltpack, you must first register it with the FreeSpeak II system. The
beltpacks can be registered to an Eclipse matrix (Omega, Median or Delta) using Eclipse HX
software (EHX).
You can register the beltpacks using a USB cable or over the air (OTA).
To register FreeSpeak beltpacks with the system see the Eclipse HX Software Configuration
User Guide, 5.59 FreeSpeak II Beltpacks.
7.11 Upgrading FS II Transceiver firmware
You can upgrade the transceiver firmware by:
l
Using a USB connection
l
Using a wireless connection.
7.12 Upgrading by USB connection
1. Connect the transceiver to a USB port on the computer running the EHX software.
2. Select Tools > Apply Wireless Firmware Via USB.
3. Browse to the location of the upgrade file, and then select Update Firmware.
The upgrade file is downloaded to the transceiver.
Page 94