FreeSpeak II for Eclipse | User Guide
1. Make sure you have to hand:
l
A beltpack
l
A transceiver
l
A power connector for the transceiver
l
Access to a power socket.
2. Connect the power to the transceiver and at the same time press the black mode button on
the base of the transceiver.
This puts the transceiver in standalone mode, and opens it for pairing to a beltpack.
3. From the beltpack, press the menu key (3 second press) and navigate to System Connect
using the right hand rotary controller on the beltpack.
4. Press button D to see local systems available for connection.
In menu mode the D key on the beltpack operates as SELECT and the C key exits the menu
level and cancels the selection.
5. Scroll through available systems using the right hand rotary controller.
6. When you have found the transceiver to pair to (it will be showing a ‘P’ to indicate that it is
ready to be paired to the beltpack) press button D to select the transceiver and connect the
beltpack to it.
7. When the beltpack is successfully connected to the transceiver, navigate to Site Survey in
the beltpack menu and monitor the range and performance of the transceiver. For more
information on Site Survey functionality see Doing a site survey with a beltpack on page
89.
Page 93
To Next Page
Loading...
Need help?
General
