FreeSpeak II for Eclipse | User Guide
5 Programming on the beltpack
This chapter explains how to program the beltpack using the beltpack's menu system. It
contains the following sections:
l
Introduction to programming on the beltpack on page 42
l
Configuring the beltpack volume settings on page 44
l
Configuring the beltpack headset on page 45
l
Configuring the beltpack microphone on page 46
l
Configuring the beltpack display and LEDs on page 47
l
Configuring the beltpack alarm options on page 48
l
Selecting the beltpack role default set on page 51
l
Selecting the beltpack administration on page 51
l
Setting the listen again option on page 52
l
Accessing beltpack information on page 53
l
Setting display mode on page 54
l
Setting system connect on page 54
l
Enabling over the air (OTA) registration mode from a beltpack on page 54
l
Performing a site survey on page 56
5.1 Introduction to programming on the beltpack
You can access the beltpack menu by pressing and holding the menu key. The Master Menu
screen is displayed. This consists of the following submenus:
l
Volume Level Control
l
Volume Operation
l
Line In Volume Level
l
Settings
l
Information
l
Display Mode
l
System Connect
Page 42
To Next Page
Loading...
Need help?
General
