FreeSpeak II for Eclipse | User Guide
6.8 Cabling the IP transceivers
Run standard Ethernet cable from one of the LAN connectors on the back of the E-IPA-HX card
to either LAN 1 or LAN 2 on the IP Transceiver via an IP switch.
6.9 Configuring the E-IPA-HX card for FreeSpeak II
Note: For more information about using the EHX configuration software to setup and configure the IP
transceiver, see the EHX Configuration Software User Guide.
6.9.1 Set card properties
Configure the network settings in Card Properties. (add graphic?)
6.9.2 Add beltpacks
When using FreeSpeak II on E-IPA-HX , each beltpack takes up a matrix port. Select the
number of beltpacks you require.
1. Navigate to Cards and Ports and select the E-IPA-HX Card slot.
2. Click +Port. The following screen appears.
Note: If you are adding more than one port, you can enter values in the Characters to
Replace and Seed value fields to automatically generate labels. For example if you
enter Label 0 in the Label field, and then enter 0 in the Characters to replace and
Seed value fields, this will automatically generate labels called Label 1, Label 2,
Label 3 up to the specified number of labels.
Page 67
To Next Page
Loading...
