FreeSpeak II for Eclipse | User Guide
5.2 Configuring the beltpack volume settings
You can configure the following:
l
The volume on each of the four channels
l
The beltpack master volume
l
The volume of the line-in feed.
5.2.1 Configuring the beltpack channel volumes and master volume
Each of the four beltpack channel volume levels is configurable separately.
Note: You can only change volume levels on keys that have been configured.
To configure a channel volume:
1. To enter the beltpack menu, press and hold the Menu key.
2. Turn either rotary control clockwise to highlight Vol Level Ctrl, and press the Menu
Select key (D). The Volume Level Control screen appears:
Use the left-hand rotary control to select the required channel, or select M for the master volume
Use the right-hand rotary control to adjust the volume level. The default is 0dB for channel
audio, and -9.6dB for master volume.
The volume level appears in the footer.
To confirm the selection, press the Menu Select key (D).
5.2.2 Configuring the volume level of the line input
You can configure the volume of an audio line input:
Page 44
To Next Page
Loading...
Need help?
General
