FreeSpeak II for Eclipse | User Guide
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Listen Again Opt > Recording
Time.
3. Use either rotary control to select a value between Off and 15 seconds.
To determine how long the message is stored:
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Listen Again Opt > Auto Delete
Time.
3. Use either rotary control to select a value between Off and 240 minutes.
5.10 Control audio on keys C & D (beltpack)(advanced menu option
only)
Pressing the menu button on your beltpack can trigger Listen Again. However, a quick tap on
the menu button can also be configured to allow volume on keys C & D to be adjusted by the
rotary controllers.
The default setting for this option is Listen Again.
To control volume on keys C & D using menu keytap:
1. Press and hold the menu button to enter menu mode.
2. Navigate to Settings/Menu key oper using the rotary controllers
3. Press key D to select menu key operation option
4. Scroll down to Switch to Vol Ctrl using rotary controllers
5. Press key D to select option.
You can now control audio volume on keys C & D using the rotary controllers (the same as you
do on keys A & B) by giving the menu key on the beltpack a quick tap, instead of using this
action to trigger Listen Again. This menu key behavior option can also be set in the EHX
software.
Note: This mode has a 5 second inactive time-out, after which time the rotary controllers will revert to
controlling volume on keys A & B. To re-activate this mode in order to adjust C & D, use another
quick tap of the menu key. To switch quickly between A & B and C & D, tap the menu key to
toggle.
5.11 Accessing beltpack information
You can access a list of beltpack information, including battery and fault-finding information.
Page 53
To Next Page
Loading...
