Clear-Com FSII-TCVR-IP-19-US User Manual

FreeSpeak II for Eclipse | User Guide
6.10.2 Online configuration
Use Detect IP TCVR to find the IPTs on the network (the AES67 interface of the E-IPA-HX card
and the IPTs must be on the same network, and the EHX software must be on the same
network as the IPA Admin port). By default, the E-IPA-HX is DHCP enabled, and the IPT is also
by default in DHCP mode.
Note: The Detect IP TCVR feature works if the IPTs are not on the same subnet, but connected to the
same network, as the AES67 interface on the E-IPA-HX card. However, for connection between
the transceiver and the card, the devices must be on the same subnet.
Note: If you reset an IPT to default settings, the device reverts to DHCP. To reset the IPT, press and
hold the Mode button on the transceiver base until the status light turns red (approx 12
seconds).
Page 69

Clear-Com FSII-TCVR-IP-19-US Specifications

General

Brand	Clear-Com
Model	FSII-TCVR-IP-19-US
Category	Intercom System
Language	English