Operating the transceiver
58 2110 SSB Transceiver Reference Manual
Adding/Editing a channel
To add or edit a channel:
1 Hold to open Quick Start.
1 Scroll to Add/Edit channel, then press .
1 Enter the name of the channel that you want to use, then press .
If you want to use an existing channel, scroll to the channel, then press .
1 Enter the receive frequency in kilohertz, then press .
1 Enter the transmit frequency in kilohertz, then press .
1 Scroll to the mode combination you want to use, then press .
The transceiver will return to Quick Start.
1 If you want to add more channels to your transceiver, scroll to Add/Edit channel
and repeat this process.
1 Press to close Quick Start, if required.
Setting up a scan list
To set up a scan list:
1 Hold to open Quick Start.
1 Scroll to Set scan list, then press .
The first channel in the transceiver will be displayed.
1 If you want to add this channel to the scan list, press .
If you do not want to add this channel to the scan list, press .
When all the channels have been viewed or you have added 20 channels to your scan
list, the transceiver will return to Quick Start.
If you do not want to scroll through all the channels in your scan list, hold to
return to Quick Start.
1 Press to close Quick Start, if required.
NOTE For help with entering text see page 52, Entering and editing text.
NOTE
You can enter the frequency to three decimal places. Press
*
to enter
a decimal point, then continue with entering the frequency.
NOTE
If you want to make or receive calls on this new channel, you must
add it to your scan list.
CAUTION
Each time you enter Set scan list, the resulting scan list will
overwrite the existing scan list.
To Next Page
Loading...
Need help?
General
