ComAp IM-NTC-BB - Page 198

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
198
12.2.14.4 Setpoint: Mains protect
Group
Act. calls/SMS
Range [units]
DISABLED, ENABLED [-]
Related FW
3.0
Force value
possible
YES
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a
"protection" configured as Mains protect occurs. See the chapter Alarm
management for more information about protection types.
NOTE:
As the Mains protect protection does not appear in the alarmlist, the SMS or
e-mail may contain empty alarmlist.
12.2.14.5 Setpoint: MainsP w/Reset
Group
Act. calls/SMS
Range [units]
DISABLED, ENABLED [-]
Related FW
3.0
Force value
possible
YES
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a
MainsP w/Reset-type alarm occurs. See the chapter Alarm management for
more information about protection types.
12.2.14.6 Setpoint: AcallCH1-Type
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Force value
possible
YES
Description
The setpoint is used to specify the alert type of the active calls - channel 1.
See the chapter Alarm messaging for more details.