InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
5 Operator guide
5.1 IM-NT
This portion of instructions is dedicated to the InteliMains-NT-GC
controller with built-in display. If you have BaseBox type of the
controller (without the built-in display) or you are using also
InteliVision with InteliMains-NT-GC, please refer to the section 5.2.
For extensive information regarding operator control use operator guide for IM-NT.
5.2 Systems with InteliVision displays
This portion of instructions is dedicated to the all
three types of controller with connected InteliVision
5 or 8. If you have InteliMains-NT-GC and you are
not using InteliVision 5 or 8 please refer to the
section 5.1.
For extensive information regarding operator control use operator guide for IGS-NT since general
functions of InteliVision displays are the same for InteliGen, InteliSys and InteliMains.
To Next Page
Loading...
