ComAp IM-NTC-BB - Configurability and monitoring

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
9
2.2 Configurability and monitoring
One of the key features of the controller is the system’s high level of adaptability to the needs of each
individual application and wide possibilities for monitoring. This can be achieved by configuring and
using the powerful ComAp PC/mobile tools.
Supported configuration and monitoring tools:
 GenConfig – complete configuration and firmware upgrade
 InteliMonitor – multiple site monitoring and setpoint setting
 WinScope – special graphical monitoring software
 WebSupervisor – web-based system for monitoring and controlling
o WebSupervisor mobile – supporting application for smartphones
NOTE:
Use the GenConfig PC software to read, view and modify configuration from the controller or disk and
write the new configuration to the controller or disk.
2.2.1 GenConfig
Configuration and monitoring tool for InteliMains
NT
,
InteliGen
NT
and other controllers. See more in
GenConfig Reference Guide.
This tool provides the following functions:
 Direct, modem or internet communication with
the controller
 Offline or online controller configuration
 Controller firmware upgrade
 Reading/writing/adjustment of setpoints
 Binary/Analog Inputs and Outputs logical functions adjustments
 Exporting data into a XLS file
 Controller language translation
 Screen Editor for editing InteliVision 5 a 8 screens
 PLC Editor for editing built-in PLC functions
 Updating and configuration of InteliVision 8 firmware
 User Protections, User sensor curves, password protection and history management
2.2.2 InteliMonitor
PC Monitoring tool for Inteli controllers. See more in the
InteliMonitor Reference Guide.
This tool provides the following functions:
 Online monitoring of a controller or whole site
 Fully customizable SCADA diagram
 Reading/writing/adjustment of setpoints
 Reading of measured values
 Browsing of controller history records