InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
4.5.2 Access group setting in GenConfig
To assign particular setpoint to access group use the following function in GenConfig (by clicking
select the correct access group).
NOTE:
Each setpoint may be assigned to only one access group. This setpoint can be changed by all users
with activated corresponding access rights.
To assign particular command to access group use the following function in GenConfig (by clicking
select the correct access group).
NOTE:
Each command may be assigned to only one access group. This command can be used by all users
with activated corresponding access rights.
4.5.3 Password break protection
Password break protection (PBP) can be adjusted to ENABLED or DISABLE by a tick box in
password management in InteliMonitor (see the figure below). Default value is ENABLED.
Warning “PassInsertBlck” is displayed in alarm list during the blocking period.
Controller does not accept attempts to insert correct or incorrect password during the blocking
period. In case of this attempt there is a message displayed in InteliMonitor, GenConfig and
InteliVision 5 and 8 which states the remaining time of blocking.
Controller is blocked for 5 minutes if there were 6 attempts to insert incorrect password. In case of
another six failed attempts (after the period of blocking elapses) the blocking period is 30, 60, 120 and
240 minutes long respectively.
To Next Page
Loading...
