ComAp IM-NTC-BB - Page 200

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
200
Force value
possible
YES
Description
The setpoint is used to specify the alert type of the active calls - channel 3.
See the chapter Alarm messaging for more details.
12.2.14.11 Setpoint: AcallCH3-Addr
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Description
The setpoint is used to specify the recipient address for the active calls -
channel 2. The content of the address must correspond to the selected alert
type (e.g. it must contain e-mail address if the alert type is e-mail). See the
chapter Alarm messaging for more details.
12.2.14.12 Setpoint: AcallCH4-Type
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Force value
possible
YES
Description
The setpoint is used to specify the alert type of the active calls - channel 4.
See the chapter Alarm messaging for more details.
12.2.14.13 Setpoint: AcallCH4-Addr
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Description
The setpoint is used to specify the recipient address for the active calls -
channel 4. The content of the address must correspond to the selected alert
type (e.g. it must contain e-mail address if the alert type is e-mail). See the
chapter Alarm messaging for more details.