ComAp IM-NTC-BB - Page 35

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
35
 Click OK
 Wait until the connection times out and following dialog appears
 Follow the instructions and then click OK (information regarding the location of boot jumper
can be found in section 3.1.4 (IM-NT-GC) or 3.2.4 (IM-NT-BB and IM-NTC-BB)
 Programming starts momentarily
 When the programming is done following dialog appears
 Follow the instructions and press OK. Following diagram will appear and programming is done