InteliATS
NT
PWR, SW version 2.5, ©ComAp – May 2015 19
IA-NT- PWR-2.5-Reference Guide.pdf
IL-NT-GPRS GSM and GPRS plug-in modem
CAUTION!
Any manipulation with plug-in module shall be done with disconnected power supply to both controller
and module. Power supply shall be switched on also is same time to both module and controller. Fail
to follow these instructions (power supply active only in controller or only in module) can lead to
module or controller failure!
This plug-in module is a GSM/GPRS modem which can work in two modes of operation based on the
settings in the setpoint COM1 Mode.
Settings DIRECT = the module works in a GPRS network and enables connection via AirGate
to LiteEdit and WebSupervisor as well as sending SMS alarms.
Settings MODEM = the module works as a standard GSM modem enabling a CSD (Circuit
Switch Data) connection to the controller with LiteEdit or InteliMonitor and sending SMS
alarms.
The communication module IL-NT GPRS works with:
WebSupervisor – internet-based remote monitoring solution
AirGate – powerful connection technology to make internet access as simple as possible
Locate – localization technology
HINT:
Quick guide how to start using this module is in chapter Remote Communication - Short guide how to
start using IL-NT-GPRS module or on ComAp webpage http://www.comap.cz/products/detail/IL-NT-
GPRS.
GPRS and CSD services must be provided by your GSM/GPRS operator for successful operation.
The GPRS and CSD connection should not be used for the firmware update process. Use instead a
wired connection like RS232, USB, RS485 or Ethernet via IB-Lite!
IL-NT-GPRS module doesn’t support a sending of e-mails.
It is necessary to power the controller and individually the IL-NT GPRS module as well.
To Next Page
Loading...
Need help?
General
