InteliATS
NT
PWR, SW version 2.5, ©ComAp – May 2015 6
IA-NT- PWR-2.5-Reference Guide.pdf
WARNING!
Every time you want to disconnect following InteliATS
NT
controller terminals:
- Mains voltage measuring and / or
- Binary output for MCB control and / or
- MCB Feedback
Switch InteliATS
NT
to MAN or OFF Mode or disconnect the Binary outputs Rem Start/Stop and GCB
Close/Open to avoid unexpected automatic start of gen-set and GCB closing.
WARNING!
Dangerous voltage
In no case touch the terminals for voltage and current measurement!
Always connect grounding terminals!
In any case do not disconnect InteliATS
NT
current transformer terminals!
The following instructions are for qualified personnel only. To avoid personal injury do not
perform any action not specified in this Reference guide!!!
To Next Page
Loading...
Need help?
General
