InteliATS
NT
PWR, SW version 2.5, ©ComAp – May 2015 63
IA-NT- PWR-2.5-Reference Guide.pdf
APN User Name [-]
User name for APN access point provided by GSM/GPRS operator.
APN User Pass [-]
User password for APN access point provided by GSM/GPRS operator.
AirGate [ENABLED/DISABLED]
This setpoint selects the ethernet connection mode.
DISABLED:
This is a standard mode, in which the controller listens to the incoming traffic
and answers the TCP/IP queries addressed to him. This mode requires the
controller to be accessible from the remote device (PC), i.e. it must be
accessible at a public and static IP address if you want to connect to it from
the Internet.
ENABLED:
This mode uses the "AirGate" service, which hides all the issues with static/public address into a black
box and you do not need to take care about it. You just need only a connection to the Internet. The
AirGate server address is adjusted by the setpoint AirGate IP.
AirGate IP [-]
This setpoint is used for entering the domain name or IP address of the AirGate server. Use the free
AirGate server provided by ComAp at address airgate.comap.cz if your company does not operate its
own AirGate server.
SMTP User Name [-]
Use this setpoint to enter the user name for the SMTP server.
SMTP User Pass [-]
Use this setpoint to enter the password for the SMTP server.
SMTP Server IP [-]
This setpoint is used for entering the domain name (e.g. smtp.yourprovider.com) or IP address (e.g.
74.125.39.109) of the SMTP server. Please ask your internet provider or IT manager for this
information.
HINT:
You may also use one of free SMTP servers, e.g. smtp.gmail.com. However, please note that some
free SMTP servers may cause delays (in hours..) when sending e-mails.
If you do not want to send active e-mails, you may leave this setpoint blank, as well as other setpoints
related to SMTP server and e-mail settings.
Proper setting of SMTP-related setpoints as well as controller mailbox are essential for sending alerts
via e-mails.
Contr Mail Box [-]
Enter an existing e-mail address into this setpoint. This address will be used as sender address in
active e-mails that will be sent from the controller.
Time Zone [-]
This setpoint is used to select the time zone where the controller is located. See your computer time
zone setting (click on the time indicator located in the rightmost position of the windows task bar) if you
are not sure about your time zone.
HINT:
If the time zone is not selected properly the active e-mails may contain incorrect information about
sending time, which may result in confusion when the respective problem actually occurred.
To Next Page
Loading...
Need help?
General
