InteliLite4 AMF20 Global Guide
258
Maintenance Timer 2 Interval
Setpoint group Maintenance Timers Related FW 1.3.0
Range [units] 1 .. 36 [month] / Disabled
Default value Disabled Alternative config NO
Step 1 month
Comm object 20584 Related applications AMF,MRS
Config level Standard
Setpoint visibility Always
Description
Maintenance timer counts down all the time, setting is done in months, but actual Maintenance Timer 2
Interval (page 413) value is displayed and counted in days. If it reaches zero, an alarm appears, but the
timer still counts down to negative values. When the value 37 (Disabled) is set, then the maintenance
function is disabled and counter does not count and the counter value disappears from controllers
statistics.
Reset of the timer can be done by adjusting this setpoint again. Setting of the setpoint does not change
when the reset is done, only the Maintenance Timer 2 Interval (page 413) value changes to reflect reset
of the maintenance timer.
6 back to List of setpoints
Maintenance Timer 2 Protection
Setpoint group Maintenance Timers Related FW 1.3.0
Range [units] Warning / BOC [-]
Default value Warning Alternative config NO
Step [-]
Comm object 20587 Related applications AMF,MRS
Config level Standard
Setpoint visibility Always
Description
Type of the maintenance alarm of both Maintenance Timer 2 RunHours (page 257) and Maintenance
Timer 2 Interval (page 258).
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
