InteliLite4 AMF20 Global Guide
285
Load Shedding Delay
Setpoint group Load Management Related FW 1.3.0
Range [units] 0.0 .. 600.0 [s]
Default value 10 s Alternative config NO
Step 1 s
Comm object 8887 Related applications AMF,MRS
Config level Advanced
Setpoint visibility Visible only if Load Shedding Active (page 284) is enabled
Description
This setpoint is used to proceeds the next Load shedding stage. When Gen-set load exceeds Load
Shedding Level (page 284) for more than this delay's time, the controller proceeds to the next Load
shedding stage – the next binary output Load Shedding Stage 1-2 is active.
6 back to List of setpoints
Subgroup:Load Reconnection Settings
Load Reconnection Level
Setpoint group Load Management Related FW 1.3.0
Range [units] 0 .. Load Shedding Level (page 284) [%]
Default value 20 % Alternative config NO
Step 1 %
Comm object 8890 Related applications AMF,MRS
Config level Advanced
Setpoint visibility Visible only if Load Shedding Active (page 284) is enabled
Description
This setpoint is used to proceed to the lower load shedding stage when the Gen-set load drops below this
level for more than Load Reconnection Delay (page 286).
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
