InteliLite4 AMF20 Global Guide
353
GPS Clock Sync
Setpoint group CM-4G-GPS Related FW 1.3.0
Range [units] Enabled / Disabled [-]
Default value Enabled Alternative config NO
Step [-]
Comm object 23974 Related applications AMF,MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint Internet
Connection (page 333)
Description
This setpoint is used to enable/disable synchronization of the controller's time with the exact time from
GPS.
The module sends UTC timestamp to the controller after reset/power on and then in period of 60minutes.
6 back to List of setpoints
Time Zone
Setpoint group
CM-4G-GPS
CM-Ethernet
Related FW 1.3.0
Range [units] GMT-12:00 .. GMT+13:00 [hours]
Default value GMT+1:00 hour Alternative config NO
Step [-]
Comm object 24366 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint is used to select the time zone where the controller is located. See your computer time zone
setting (click on the time indicator located in the rightmost position of the Windows task bar) if you are not
sure about your time zone.
Note: If the time zone is not selected properly the active e-mails may contain incorrect information
about sending time, which may result in confusion when the respective problem actually occurred.
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
