InteliLite4 AMF20 Global Guide
355
IP Address
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] 0 .. 15 characters [-]
Default value 192.168.1.254 Alternative config NO
Step [-]
Comm object 23950 Related applications AMF,MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint IP Address Mode
(page 354)
Description
The setpoint is used to set the address when you are in static mode.
If IP Address Mode (page 354) is MANUAL this setpoint is used to adjust the IP address of the ethernet
interface of the controller. Ask your IT specialist for help with this setting.
If IP Address Mode (page 354) is AUTOMATIC this setpoint is inactive. The IP address is assigned by
the DHCP server.
If IP Address Mode (page 354) is DISABLED Ethernet terminal is disabled.
Note: Only valid IP address can be inserted.
6 back to List of setpoints
Subnet Mask
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] Valid IP address [-]
Default value 255.255.255.0 Alternative config NO
Step [-]
Comm object 23949 Related applications AMF,MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint IP Address Mode
(page 354)
Description
The setpoint is used to select the method how the Subnet Mask is adjusted.
If IP Address Mode (page 354) is MANUAL this setpoint is used to adjust the Subnet Mask. Ask your IT
specialist for help with this setting.
If IP Address Mode (page 354) is AUTOMATIC this setpoint is inactive. The Subnet Mask is assigned by
the DHCP server.
If IP Address Mode (page 354) is DISABLED Ethernet terminal is disabled.
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
