InteliLite4 AMF20 Global Guide
360
Subgroup:ComAp Client Settings
Direct Connection
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] Disabled / Enabled [-]
Default value Enabled Alternative config NO
Step [-]
Comm object 23917 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
Use this to enable/disable direct connection of a ComAp client (e.g. InteliConfig) to the IP address of the
controller.
Note: For Direct connection the controller IP address must be reachable from the client IP address.
6 back to List of setpoints
Direct Connection Port
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] 1 .. 65535 [-]
Default value 23 Alternative config NO
Step [-]
Comm object 23918 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This port is used to listen for an incoming TCP connection if Direct Connection is ENABLED.
6 back to List of setpoints
To Next Page
Loading...
