ComAp InteliLite 4 AMF 20 User Manual

InteliLite4 AMF20 Global Guide
362
Subgroup:SNMP Settings
SNMP Agent
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] DISABLED / ENABLED [-]
Default value DISABLED Alternative config NO
Step [-]
Comm object 23936 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
Enable or disable SNMP Agent.
6 back to List of setpoints
SNMP Trap Format
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] v1Trap / v2Notif / v2Inform [-]
Default value v1Trap Alternative config NO
Step [-]
Comm object 23922 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint adjusts type of SNMP traps.
6 back to List of setpoints
SNMP Traps IP Address 1
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] Valid IP address [-]
Default value DISABLED Alternative config NO
Step [-]
Comm object 24095 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
IP address 1 for receiving SNMP Traps. Leave this setpoint blank if SNMP traps should not be send.
6 back to List of setpoints

ComAp InteliLite 4 AMF 20 Specifications

General

Brand	ComAp
Model	InteliLite 4 AMF 20
Category	Controller
Language	English