InteliLite4 AMF20 Global Guide
372
Time Zone
Setpoint group
CM-4G-GPS
CM-Ethernet
Related FW 1.3.0
Range [units] GMT-12:00 .. GMT+13:00 [hours]
Default value GMT+1:00 hour Alternative config NO
Step [-]
Comm object 24366 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint is used to select the time zone where the controller is located. See your computer time zone
setting (click on the time indicator located in the rightmost position of the Windows task bar) if you are not
sure about your time zone.
Note: If the time zone is not selected properly the active e-mails may contain incorrect information
about sending time, which may result in confusion when the respective problem actually occurred.
6 back to List of setpoints
Group: Alternate Config
Subgroup:Configuration 1
Nominal RPM 1
Setpoint group Alternate Config Related FW 1.3.0
Range [units] 100 .. 4000 [RPM]
Default value 1 500 RPM Alternative config YES
Step 1 RPM
Comm object 9915 Related applications AMF,MRS
Config level Advanced
Setpoint visibility Always
Description
Nominal engine speed (RPM revolutions per minute).
Note: This value is used when any other alternate configuration is not active.
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
