ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
218
Setpoint group Engine settings Related FW 1.9.0
Range [units] Fuel Pump On (page 217) .. 100 [%]
Default value 90 % Alternative config NO
Step 1 %
Comm object 10101 Related applications AMF, MRS
Config level Advanced
Setpoint visibility
Visible only if the logical binary output FUEL PUMP (PAGE 572) is configured and
logical binary input FUEL PUMP ON/OFF (PAGE 529) isn’t configured
Description
Threshold level for switching the binary output FUEL PUMP (PAGE 572) off.
Image 8.14 Fuel Pump Off
IMPORTANT: When binary input FUEL PUMP ON/OFF (PAGE 529) is configured then binary
output FUEL PUMP (PAGE 572) is control by this binary input. Setpoints Fuel Pump On (page
217) and Fuel Pump Off are not evaluated!
Note: Value from analog input has higher priority than ECU.
Note: This setpoint is visible only if the logical binary output FUEL PUMP (PAGE 572) is configured.
Fuel Pump Off
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65