ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
223
Setpoint group Engine settings Related FW 1.9.0
Range [units] 0 ... 1 000 [-]
Default value 1 Alternative config NO
Step 1
Comm object 10995 Related applications AMF, MRS
Config level Advanced
Setpoint visibility Only if LBI PULSE COUNTER 2 (PAGE 535) is configured
Description
This setpoint adjusts the rate of increasing of the Pulse Counter 2 function. The module counts pulses at the
input PULSE COUNTER 2 (PAGE 535) and if the input pulses counter reaches value given by this setpoint, the
counter value Pulse Counter 2 (page 470) is increased by 0,1 and input pulses counter is reset to 0. Both
counter value and input pulses counter are stored in the nonvolatile memory.
Conversion Coefficient Pulse 2
6 back to List of setpoints
Subgroup: Power switch
Setpoint group Engine settings Related FW 1.9.0
Range [units] 0 .. 32 000 [kW]
Default value 100 kW Alternative config NO
Step 1 kW
Comm object 11658 Related applications AMF, MRS
Config level Advanced
Setpoint visibility Visible only if the logical binary output POWER SWITCH (PAGE 585) is configured.
Description
Threshold level for switching the binary output POWER SWITCH (PAGE 585) on.
Image 8.15 Power Switch Level On < Level Off
Power Switch On

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65