ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
363
Setpoint group
CM-GPRS; CM-4G-
GPS; CM-Ethernet
Related FW 1.9.0
Range [units] 0..63 characters [-]
Default value [-] Alternative config NO
Step [-]
Comm object 24144 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint Internet Connection
(page 359) (CM-GPRS and CM-4G-GPS modules)
Description
Enter in this setpoint a valid e-mail address where the alarm and event e-mails shall be sent. Leave this
setpoint blank if alarm and event email should not be send.
Note: This setpoint is common for CM-Ethernet, CM-GPRS and CM-4G-GPS modules.
Email Address 4
6 back to List of setpoints
Setpoint group
CM-GPRS; CM-4G-
GPS; CM-Ethernet
Related FW 1.9.0
Range [units] [-]
Default value English Alternative config NO
Step [-]
Comm object 24299 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
Use this setpoint to set the language of SMS and e-mail.
Note: Numbers correspond with languages in language list. See the chapter for Language selection
(page 81) more information.
This setpoint is common for CM-Ethernet, CM-GPRS and CM-4G-GPS modules.
Message Language
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65